Home View Cart Register

Haltech Platinum Sprint RE ECU/EMS - 2003-11 RX-8 SE3P

Starting at: $789.00

Please Choose:

Add to Cart:   
  • Model: HT050900, HT050902 J
  • Manufactured by: Haltech

Haltech High Performance Fuel and Ignition ECU. Available as ECU only or with the flying lead long harness kit. Select from menu above.

Engine Suitability:
• 2 Rotor Engines - 2nd Generation RX7 (FC3S)/Turbo II, 3rd Generation RX7 (FD3S) and RX8 (SE3P)
• Normally Aspirated or forced induction
• Load sensing by throttle position or manifold pressure (MAP)
• Sequential Injection
• Distributor ignition systems or multi-coil systems

Trigger Types:
• Reluctor

Trigger Patterns:
• Mazda Rotary Multi-tooth 24 and 2
• Mazda Rotary RX8

• Windows 2000, XP, Vista, Windows 7 compatible software
• Real time programming, instant hesitation free adjustment while engine is running
• Fully user definable 16 x 16 mapping
• Tuning via Injection time
• Supports staged fueling
• Selectable onboard internal MAP sensor rated to 150kPa (up to 1.5 Bar or 22psi boost)
• USB and CAN Communication Port
• Custom sensor calibration allows for most factory sensors to be used
• 2 x User programmable outputs

ECU Fixed Outputs:
• 4 x Fuel Injector outputs (for high impedance injectors only (ie: above 8Ω)
• 4 x Ignition outputs
• Tacho
• Thermo Fan
• Fuel Pump

ECU Programmable Outputs:
• 2 x Programmable Outputs

ECU Inputs:
• Air Temperature
• Aux Rev Limiter
• Coolant Temperature
• Manifold Absolute Pressure
• Roadspeed
• Throttle Position
• O2 Sensor (Narrowband or Wideband)

• CAN Communication
• O2 Control
• Over Boost
• Gear Setup
• Decel Cut
• Transient Throttle Enhance
• Rev Limiter

Correction Tables: Fuel / Ignition:
• Air Temp Correction
• Barometric Correction
• Coolant Temperature Correction
• Injector Dead Time
• Map Correction
• Post Start
• Prime Pulse
• Staging Bar Injection Time
• Throttle
• Zero Throttle

• Tune can be password protected in software
• Small and compact design
• Rugged anodized aluminum casing

Power Requirements:
Source: 8.6 to 16.5 Volts DC
Consumption: 360mA @ 12Volts DC

Physical Dimensions:
ECU Dimensions Length: 134mm (154mm with MAP nipple)
Width: 64mm Height: 28mm Weight: 195g (0.43 lb)

The Platinum Sprint RE kit includes:
ECU Programmable Computer, Flying Loom, USB Programming Cable, Instruction
Manual (on CD),Programming software, Quick
Start Guide, Haltech Sticker

Note::Base ecu only kit includes:
ECU Programmable Computer, USB Programming Cable, Instruction Manual, (In Software) Programming software & Haltech Sticker. Includes flying lead (no connectors on the engine side pre-installed, requires user to install their own connectors) harness only when selected in the menu. Sprint RE w/ long harness shown in picture.

Copyright © 2005-2019. All rights reserved www.himniracing.com
Terms of use