Home View Cart Register

HR GT Turbo Water / Oil Installation Kit : GT25R - GT35R

$78.00



Add to Cart:   
  • Model: HRGTKit
  • Manufactured by: Himni Racing

For use with All small to mid frame Garrett GT series ball bearing turbos (GT25R - GT35R)

This Himni Racing GT turbo installation kit will make installing your new turbo a snap. It contains all the basic items needed for water, oil feed & oil return on the turbo it's self. (everything bolts to the turbo) Simply contact lines/ hoses & you're ready to go.

Kit comes with everything needed / seen in the picture:
(1) GT Oil Feed fitting with built in restrictor (.035)
(1) GT Oil Return Flange with 1/2 NPT female threads
(1) GT Oil Return flange Gasket
(1) Oil return Fitting (Fits flange above & works with -10 or 5/8" line)
(2) Banjo Water Fitting sets

Notes:
::::: The oil feed fitting with built in resticter is a must have for most of the Garrett BB small to mid frame turbos. These turbos do not require as much oil & too much oil being fed can blow the seals. It works with your choice of -3 or -4 feed line. (pick from fitting size from menu, -4 is most common)
:::::: Water fittings: each set comes with 1 banjo fitting, 1 banjo bolt, 2 seals / washers. They bolt right onto the turbo then just connect any 3/8" hose to them.

The kit works with the following turbos:
Garrett GT25R, GT2554R, GT28R, GT28RS, GTX2860R,GT2863R, GTX2867R GT2871R, GT2876R, GT3071R, GTX3071R, GT3076R-WG, GT30R, GT3076R, GTX3076R, GT3040R, GT3082R, GTX3576R, GT35R, GT3582R, GTX3582R, etc.
For lines, hoses & other fittings, click the 'Fittings & Lines' category on the left side bar.


  
bottom
Copyright © 2005-2017. All rights reserved www.himniracing.com
Terms of use